Removal and Installation: Installation

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Install the engine coolant temperature sensor.
Use Genuine RTV Silicone Sealant or equivalent. Refer to RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS .
Install the water control valve with the whole circumference of the flange part fitting securely inside the rubber ring.
Install the water control valve with the up-mark facing up and the frame center part facing upwards. The position deviation may be within the range of +/- 10°.