Cruise Test - Part 2
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK STARTING GEAR (D1) POSITION
- Confirm overdrive control switch is in ON position.
- Confirm selector lever is in D position.
- Accelerate vehicle by half throttle again.
- Does vehicle start from D1 ?
Read gear position.
Yes or No
- Yes: GO TO 2.
- No: Go to 16. Vehicle Does Not Start From D1 . Continue ROAD TEST.
- CHECK SHIFT UP AND SHIFT DOWN (D4 TO D2)
- Accelerate vehicle to 80 km/h (50 MPH) as shown.
- Release accelerator pedal and then quickly depress it fully.
- Does A/T shift from D4 to D2 as soon as accelerator pedal is depressed fully?
Read gear position and throttle opening.
Yes or No
- Yes: GO TO 3.
- No: Go to 9. A/T Does Not Shift: D1 --> D2 or Does Not Kickdown: D4 --> D2 . Continue ROAD TEST.
- CHECK SHIFT UP (D2 TO D3)
Does A/T shift from D2 to D3 at the specified speed?
Courtesy of NISSAN MOTOR CO., U.S.A.
Read gear position, throttle opening and vehicle speed.
- Specified speed when shifting from D2 to D3: Refer to SHIFT SCHEDULE .
Yes or No
- Yes: GO TO 4.
- No: Go to 10. A/T Does Not Shift: D2 --> D3 . Continue ROAD TEST.
- CHECK SHIFT UP (D3 TO D4) AND ENGINE BRAKE
Release accelerator pedal after shifting from D2 to D3.
Courtesy of NISSAN MOTOR CO., U.S.A.
Does A/T shift from D3 to D4 and does vehicle decelerate by engine brake?
Read gear position, throttle opening and vehicle speed.
Yes or No
- Yes:
- Stop vehicle.
- Go to CRUISE TEST-PART 3 .
- No: Go to 11. A/T DOES NOT SHIFT: D3 --> D4 . Continue ROAD TEST.
- Yes: