Stall Test Procedure
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
- Check A/T fluid and engine oil levels. If necessary, add.
- Drive vehicle for approx. 10 minutes or until fluid and oil reach operating temperature.
ATF operating temperature: 50-80°C (122 - 176°F)
- Set parking brake and block wheels.
- Install a tachometer where it can be seen by driver during test.
- It is good practice to mark the point of specified engine rpm on indicator .
- Start engine, apply foot brake, and place selector lever in D position.
- Accelerate to wide open throttle gradually while applying foot brake.
- Quickly note the engine stall revolution and immediately release throttle.
- During test, never hold throttle wide open for more than 5 seconds
.
Stall revolution
QG18DE: 2,350 - 2,800 rpm
- During test, never hold throttle wide open for more than 5 seconds
.
- Move selector lever to N position.
- Cool off ATF.
- Run engine at idle for at least one minute .
- Repeat steps 5 through 9 with selector lever in 2 , 1 and R positions.