Cruise Test - Part 2

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

CHECK STARTING GEAR (D1) POSITION
1. Confirm overdrive control switch is in ON position.
2. Confirm A/T selector lever is in D position.
3. Accelerate vehicle by half throttle again.
4. Does vehicle start from D1?
  Read gear position .
Yes or No
1. Yes: GO TO 2.
2. No: go to 16. VEHICLE DOES NOT START FROM D1 . Continue ROAD TEST.
CHECK SHIFT UP AND SHIFT DOWN (D3 TO D4 TO D2)
1. Accelerate vehicle to 80 km/h (50 MPH) .
2. Release accelerator pedal and then quickly depress it fully.
3. Does A/T shift from D4 to D2 as soon as accelerator pedal is depressed fully?
  Read gear position and throttle position .
Yes or No
1. Yes: GO TO 3.
2. No: go to 9. A/T DOES NOT SHIFT: D1 --> D2 OR DOES NOT KICKDOWN: D4 --> D2 . Continue ROAD TEST.
CHECK SHIFT UP (D2 TO D3)
Does A/T shift from D2 to D3 at the specified speed?

Read gear position, throttle position and vehicle speed .

Specified speed when: Refer to Shift shifting from D2 to D3 Schedule .

Yes or No
1. Yes: GO TO 4.
2. No: go to 10. A/T DOES NOT SHIFT: D2 --> D3 . Continue ROAD TEST.