LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 773 (Clutch System QG18DE) >> Clutch Master Cylinder >> Assembly

Clutch Master Cylinder: Assembly

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install spring.
  2. Apply rubber lubricant to the sliding part of piston assembly, and insert piston assembly into cylinder body.
  3. After installing stopper to push rod, install stopper ring while keeping piston assembly depressed by hand, so that piston assembly will not pop out.
    CAUTION: Stopper ring cannot be reused. Always use a new stopper ring for assembly.
  4. Apply silicone grease, and install dust cover.
  5. Install clevis to push rod, and tighten lock nut "A" to the specified torque.
    1. : 7.8-10.8 N.m (0.8 -1.1 kg-m, 69- 95 in-lb) 
  6. Install seal and nipple to cylinder body, and install pin using a pin punch.
scientia non olet · About LEMON Manuals