LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0600: A/T Control (3.3L) >> DTC Confirmation Test (Without CONSULT-II)

DTC Confirmation Test (Without CONSULT-II)

WARNING: This page is about a different car, the 2002 Nissan Xterra and 2002 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use the following test to check overall function of A/T control circuit. During this test, DTC may not be confirmed.
  1. Start engine. Measure voltage between ground and ECM terminals No. 26 (Purple/White wire) and No. 27 (Pink/Black wire) by backprobing. See Figure or Figure . See Figure .
  2. Voltage should be 6-8 volts. If voltage is not as specified, go to DIAGNOSTIC PROCEDURE  . If voltage is as specified, system is okay at this time.
scientia non olet · About LEMON Manuals