DTC Confirmation Test (Without CONSULT-II)
WARNING: This page is about a different car, the 2002 Nissan Xterra and 2002 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the following test to check overall function of closed TP switch circuit. During this test, 1st trip DTC may not be confirmed.
- Start engine and warm to normal operating temperature. Measure voltage between ground and closed TP switch signal circuit (Brown/White wire) at ECM terminal No. 28 by backprobing. See Figure or Figure . See Figure .
- At idle, battery voltage should exist. At 2000 RPM, voltage should be 0-1 volt. If voltage is as specified, system is okay at this time. If voltage is not as specified, go to appropriate DIAGNOSTIC PROCEDURE.