DTC Confirmation Test "C"
WARNING: This page is about a different car, the 2002 Nissan Xterra and 2002 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition on. Select DATA MONITOR mode with scan tool. Start engine and warm to normal operating temperature. Run engine for at least 10 seconds at idle speed.NOTE: If engine stalls or will not start, wait at least 10 seconds with ignition on.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, turn ignition off, wait at least 5 seconds and go to appropriate DTC CONFIRMATION TEST "D" .