DTC Confirmation Test (Using CONSULT-II)
WARNING: This page is about a different car, the 2002 Nissan Pathfinder and 2002 Infiniti QX4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing. Before proceeding, ensure battery voltage is more than 11 volts at idle.
- Start engine and warm to normal operating temperature.
- Select HO2S 1 (B1) P0134 or HO2S 1 (B2) P0154 in DTC WORK SUPPORT mode with CONSULT-II.
- Press START.
- Allow engine to idle for at least 3 minutes.NOTE: DO NOT exceed 3600 RPM. If engine speed exceeds 3600 RPM, return to step 4 .
- When the following conditions are met, TESTING will be displayed on CONSULT-II screen:
- ENG SPEED: 1500-2800 RPM.
- Vehicle speed: 43 MPH or more.
- B/FUEL SCHDL: 3.0-10 msec (as displayed on CONSULT-II).
Maintain conditions continuously until TESTING changes to COMPLETED (it will take 10-60 seconds). If TESTING is not displayed after 5 minutes, retry from step 2 .
- Press SELF-DIAG RESULTS. If NG is displayed, go to DIAGNOSTIC PROCEDURE . If OK is displayed, system is okay at this time.