DTC Confirmation Test
WARNING: This page is about a different car, the 2002 Nissan Pathfinder and 2002 Infiniti QX4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If DTC confirmation procedure had been previously run, turn ignition off and wait at least 10 seconds before continuing.
NOTE:
Before proceeding, ensure battery voltage is 10 volts or more at idle.
Turn ignition on. On scan tool, select DATA MONITOR mode. Start engine and let it idle for 5 seconds. If DTC is detected, go to DIAGNOSTIC PROCEDURE . If DTC is not detected, system is okay at this time.