LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Disc Brakes) >> Removal & Installation >> Power Brake Unit >> Installation

Power Brake Unit: Installation

WARNING: This page is about a different car, the 2004 Nissan Altima, 2003 Nissan Altima, and 2002 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the length of the input rod. See POWER BRAKE UNIT INPUT & OUTPUT ROD  under ADJUSTMENTS. Tighten the lock nut temporarily and install the booster assembly in the vehicle. Connect the brake pedal to the clevis of the input rod.
  2. Tighten the mounting nut for the brake pedal assembly to specification. See TORQUE SPECIFICATIONS  . Install the master cylinder on the booster assembly. See MASTER CYLINDER  .
  3. Adjust the height and play of the brake pedal. See BRAKE PEDAL FREE PLAY  and BRAKE PEDAL HEIGHT  under ADJUSTMENTS.
  4. Tighten the lock nut of the input rod to the specified torque. See TORQUE SPECIFICATIONS  . Bleed air from brake system. See BLEEDING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals