LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Controls - System & Component Testing - 4 CYL & V6) >> Relays & Solenoids >> Relays >> ECM & Fuel Pump Relays

ECM & Fuel Pump Relays

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Nissan Xterra, 2002 Nissan Sentra, 2002 Nissan Quest, 2002 Nissan Pathfinder, and 2002 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Two types of relays are used: 4-terminal and 6-terminal. For relay location, see ECM & FUEL PUMP RELAY LOCATIONS  table. Remove appropriate relay. Apply battery voltage and ground to terminals No. 1 and 2. See Figure and Figure .
  2. On 4-pin relays, continuity should exist between terminals No. 3 and 5. On 6-terminal relays, continuity should exist between terminals No. 3, 5, 6 and 7. On all relays, when battery voltage is removed, continuity should not exist. Replace relay, if test values are not as specified.
ECM & FUEL PUMP RELAY LOCATIONS

Application Location
Altima
ECM Relay Near ECM
Fuel Pump Relay On Passenger Compartment Fuse Block
Frontier & Xterra
ECM Relay Above ECM
Fuel Pump Relay Behind Instrument Panel, Above Parking Brake Lever
I35 & Maxima
ECM Relay In Underhood Relay Box
Fuel Pump Relay Behind Left Kick Panel
Pathfinder & QX4
ECM Relay & Fuel Pump Relay In Underhood Relay Box
Quest
ECM Relay Above ECM
Fuel Pump Relay In Underhood Relay Box
Sentra
ECM Relay At Rear Of ECM, Accessible From Behind Glove Box
Fuel Pump Relay Behind Left Kick Panel