LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Controls - System & Component Testing - 4 CYL & V6) >> Ignition System >> Ignition Coil (Frontier, XTERRA & Quest)

Ignition Coil (Frontier, XTERRA & Quest)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Nissan Xterra, 2002 Nissan Sentra, 2002 Nissan Quest, 2002 Nissan Pathfinder, and 2002 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Ignition coil is located in distributor. Turn ignition off. Disconnect distributor 2-pin harness connector (ignition coil connector). Remove distributor cap. For primary coil, measure resistance between distributor 2-pin connector terminals (component side). For secondary coil, measure resistance between distributor 2-pin connector terminal No. 7 and coil tower. See Fig 1. See IGNITION COIL RESISTANCE (FRONTIER, XTERRA & QUEST)  table. Replace distributor assembly, if resistance is not as specified.

IGNITION COIL RESISTANCE (FRONTIER, XTERRA & QUEST)

Application Primary Secondary
Frontier & Xterra
2.4L Less Than 1 Ohm @ 77°F (25°C) 7-13 K/Ohms @ 77°F (25°C)
3.3L .5-1.0 Ohm @ 77°F (25°C) About 12 K/Ohms @ 77°F (25°C)
Quest .5-1.0 Ohm @ 77°F (25°C) About 12 K/Ohms @ 77°F (25°C)
Fig 1: Testing Ignition Coil (Frontier, Xterra & Quest)
G99A51912Courtesy of NISSAN MOTOR CO., U.S.A.