With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Start engine and select "DATA MONITOR" mode for "TRANSMISSION" with Consult-II.

Fig 1: Consult-II Display Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure that ATF temperature is within the range below.
FLUID TEMP: More than 20°C (68°F)

If out of range, drive the vehicle to warm up the fluid.
Accelerate vehicle to more than 100 km/h (62 MPH) and maintain the following conditions for at least 12 consecutive seconds.
SLCT LVR POSI: "D" position

GEAR: 5th position

SLIP REV: Less than 100 rpm

ACCELE ANGLE: More than 5%

LOCK-UP: ON (Refer to "VEHICLE SPEED WHEN PERFORMING AND RELEASING COMPLETE LOCK-UP ".)

[Vehicle speed: Constant speed of more than 100 km/h (62 MPH).]

Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
If DTC is detected, go to "Diagnostic Procedure ".