LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 420 (Clutch) >> Clutch Master Cylinder >> Disassembly And Assembly >> Assembly

Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply rubber lubricant to the sliding part of piston assembly, and insert piston assembly.
  2. After installing stopper to push rod, install a new stopper ring while keeping piston assembly depressed by hand, so that piston assembly will not pop out.
    CAUTION: Stopper ring cannot be reused. Always use a new stopper ring to assemble.
  3. Install dust cover.
  4. Install clevis to push rod, and tighten lock nut "A" to specification.

    Lock nut "A" tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kg-m, 69 - 104 in-lb) 

  5. Install seal and nipple to cylinder body.
scientia non olet · About LEMON Manuals