LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 414 (Engine Control System - DTC) >> DTC P0441: EVAP Control System >> Diagnostic Procedure >> 5. Check EVAP Purge Hose And Purge Port

5. Check EVAP Purge Hose And Purge Port

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect purge hoses connected to EVAP service port A  and EVAP canister purge volume control solenoid valve B  .
  2. Blow air into each hose and EVAP purge port C. 
    Fig 1: Check EVAP Purge Hose And Purge Port
    G00874667Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Check that air flows freely.

OK or NG 

  1. OK: (With CONSULT-II): GO TO 6.
  2. OK (Without CONSULT-II): GO TO 7 .
  3. NG: Repair or clean hoses and/or purge port.
Fig 2: Check That Air Flows Freely
G00874668Courtesy of NISSAN MOTOR CO., U.S.A.