LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 413 (Engine Mechanical - 3.5L) >> Rocker Cover >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover, using power tool.
  2. Drain engine coolant. Refer to V6 .
  3. Disconnect the mass air flow sensor electrical connector and remove the air cleaner assembly and air intake tubes. Refer to REMOVAL AND INSTALLATION  .
  4. Remove the windshield wiper arms and motor assembly and the front cowl panel. .
  5. Remove the intake manifold collector using power tool. Remove gasket and the electric throttle control actuator. Refer to REMOVAL AND INSTALLATION  .
  6. Remove the six ignition coils. Refer to REMOVAL AND INSTALLATION  .
  7. Remove the two intake valve timing control solenoid valves and gaskets. Refer to INTAKE VALVE TIMING CONTROL SOLENOID VALVE (3.5L ENGINE) .
  8. Remove RH and LH rocker covers from cylinder head.
    • Follow the loosening sequence for each side rocker cover bolts as shown.
    Fig 1: View Of Rocker Cover Bolt
    G02110569Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals