LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 413 (Engine Mechanical - 3.5L) >> Cylinder Head >> Disassembly And Assembly >> Disassembly

Disassembly And Assembly: Disassembly

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove valve lifter.
    • Mark position for installation.
  2. Remove valve collet.
    • Compress valve spring with valve spring compressor. Remove valve collet with magnet driver.
  3. Remove valve spring retainer, valve spring, and valve spring seat.
  4. Push valve stem to combustion chamber side, and remove valve, mark for assembly.
    • Inspect valve guide clearance before removal. Refer to VALVE GUIDE CLEARANCE  .
    • Confirm installation point.
    Fig 1: View Of Compressing Valve Spring
    G02110703Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove the valve oil seals.
  6. If valve seat must be replaced, Refer to VALVE SEAT REPLACEMENT  .
  7. If valve guide must be replaced, Refer to VALVE GUIDE REPLACEMENT  .
  8. Remove spark plug with spark plug wrench.
scientia non olet · About LEMON Manuals