DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Ensure battery voltage battery voltage is greater than 11 volts at idle before performing this confirmation procedure.

Malfunction is detected when improper voltage is sent to ECM through EVAP Canister Purge Volume Control Valve (EVAP-CPVCV). Possible causes are:

EVAP-CPVCV circuit open or shorted.
Defective EVAP-CPVCV.

To set DTC, turn ignition on. Using scan tool, select DATA MONITOR. Start engine and let it idle for at least 13 seconds. If first trip DTC is detected, perform DIAGNOSTIC PROCEDURE .