DTC Confirmation Test
WARNING: This page is about a different car, the 2002 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Malfunction is detected when HO2S voltage is too high. Possible causes are:
- HO2S circuit open or shorted.
- Defective HO2S.
To set DTC, start engine and warm to normal operating temperature. Turn ignition off and wait at least 5 seconds. Start engine and let it idle for 20 seconds. Turn ignition off and wait at least 5 seconds. Start engine and let it idle for 20 seconds. Using scan tool, retrieve DTCs. If DTC is detected, perform DIAGNOSTIC PROCEDURE .