DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before performing confirmation test, ensure battery voltage is greater than 11 volts when engine is idling.

Malfunction is detected when ECM receives an excessively low or high voltage from knock sensor. Possible causes are:

Knock sensor circuit open or shorted.
Defective knock sensor.

To set DTC, turn ignition on. Using scan tool, select DATA MONITOR. Start engine and let it idle for at least 5 seconds. If first trip DTC is detected, perform DIAGNOSTIC PROCEDURE .