LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Controls - Self-Diagnostics - 2.5) >> Diagnostic Tests >> DTC P0101, DTC P0102, DTC P0103 & P1102 >> DTC Confirmation Test "C"

DTC Confirmation Test "C"

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Malfunction "C" is detected when ECM receives a high voltage from MAF sensor under light-load driving conditions. Possible causes are:

To set DTC, turn ignition on. Select DATA MONITOR with scan tool. Start engine and warm to normal operating temperature. Let engine idle for at least 10 seconds. If engine stalls or will not start, leave ignition on without starting engine for at least 10 seconds. If first trip DTC is detected, go to DIAGNOSTIC PROCEDURE .

scientia non olet · About LEMON Manuals