LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Self-Diagnostics - 1.8L - XE, GXE) >> Diagnostic Tests >> DTC P0340: Camshaft Position Sensor Circuit >> DTC Confirmation Test

DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC confirmation test has been previously performed, always turn ignition off and wait at least 10 seconds before performing the next test.
NOTE: Before proceeding, ensure battery voltage is more than 10.5 volts.
  1. Turn ignition on. Select DATA MONITOR with scan tool. Crank engine for at least 2 seconds and run engine at idle for at least 5 seconds.
  2. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals