LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Self-Diagnostics - 1.8L - XE, GXE) >> Diagnostic Tests >> DTC P0132 Or DTC P0152 >> DTC Confirmation Test

DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC confirmation test has been previously performed, always turn ignition off and wait at least 10 seconds before performing the next test.

With CONSULT-II

  1. Start engine and warm to normal operating temperature. Turn ignition off and wait at least 10 seconds. Turn ignition on. Select DATA MONITOR mode with CONSULT-II.
  2. Start engine and let it idle for 2 minutes. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.

With Generic Scan Tool

  1. Start engine and warm to normal operating temperature. Turn ignition off and wait at least 10 seconds. Start engine and let it idle for 2 minutes. Turn ignition off and wait at least 10 seconds. Start engine and let it idle for 2 minutes.
  2. Select MODE 3 with scan tool. If DTC is detected, go to DIAGNOSTIC PROCEDURE  . If DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals