DTC Confirmation Test
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If DTC confirmation test has been previously performed, always turn ignition off and wait at least 10 seconds before performing the next test.
- Turn ignition on. Select DATA MONITOR mode with scan tool. Ensure COOLAN TEMP/S reading on scan tool is less than 50°F (10°C). Start engine and let it idle for at least 65 minutes.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.