DTC Confirmation Test
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC confirmation test has been previously performed, always turn ignition off and wait at least 10 seconds before performing the next test.
With CONSULT-II
- Turn ignition on. Select DATA MONITOR mode with CONSULT-II. Start engine. Drive vehicle at a speed of more than 43 MPH for 2 consecutive minutes.
- Stop vehicle. Let engine idle for at least 6 seconds. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.
With Generic Scan Tool
- Start engine. Drive vehicle at a speed of more than 43 MPH for 2 consecutive minutes. Stop vehicle. Let engine idle for at least 6 seconds.
- Turn ignition off and wait at least 10 seconds. Repeat step 1 . Select MODE 3 with scan tool.
- If DTC is detected, go to DIAGNOSTIC PROCEDURE . If DTC is not detected, system is okay at this time.