LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P1706: Park/Neutral Position Switch >> DTC Confirmation Test (Using CONSULT-II)

DTC Confirmation Test (Using CONSULT-II)

WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on. Select P/N POSI SW in DATA MONITOR mode with CONSULT-II.
  2. Check P/N POSI SW signal under the following conditions.
    • With transmission in Park or Neutral, ON should be displayed.
    • With transmission not in Park or Neutral, OFF should be displayed.

    If operation is as specified, go to next step. If operation is not as specified, go to appropriate DIAGNOSTIC PROCEDURE.

  3. Select DATA MONITOR mode with CONSULT-II. Start engine and warm to normal operating temperature.
  4. Maintain the following conditions for at least 50 consecutive seconds:
    • ENG SPEED: more than 1400 RPM.
    • COOLAN TEMP/S: more than 158°F (70°C).
    • B/FUEL SCHDL: more than 2 msec.
    • VHCL SPEED SE: more than 40 MPH.

    If 1st trip DTC is detected, go to appropriate DIAGNOSTIC PROCEDURE. If 1st trip DTC is not detected, system is okay at this time.

scientia non olet · About LEMON Manuals