Diagnostic Procedure
WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect ECM harness connector. See Figure . Measure voltage between ground and ECM harness connector terminal No. 67 (White/Blue wire). See Figure . If battery voltage exists, go to step 3 . If battery voltage does not exist, go to next step.
- Check the following:
- Check for poor connection at Black, 8-pin connector F18 terminal No. 2 (White/Blue wire). See Figure . For location, see Figure or Figure .
- Check fuse No. 59 (15-amp) located in fuse and fusible link box on left side of engine compartment.
- Check for open or short between ECM and fuse.
- On I35, check White, 6-pin joint connector No. 13 (connector E74) located in relay box on right side of engine compartment. See Figure and Fig 1 .
- On Maxima, check White, 6-pin joint connector No. 12 (connector E73) located in relay box on right side of engine compartment. See Figure and Fig 1 .
On all models, repair as necessary.
- Check for intermittent condition. See INTERMITTENTS in TROUBLE SHOOTING - NO CODES article. If problem is found, repair as necessary. If problem is not found, go to next step.
- Reconnect all harness connectors. If using CONSULT-II, go to next step. If using generic scan tool, go to step 6 .
- Turn ignition on. Select SELF-DIAG RESULTS mode with CONSULT-II. Press ERASE. Perform DTC CONFIRMATION TEST . If 1st trip DTC P1065 is detected again, replace ECM. If 1st trip DTC P1065 is not detected, test is complete.
- Turn ignition on. Using scan tool, select MODE 4 and clear DTCs. Perform DTC CONFIRMATION TEST . If 1st trip DTC P1065 is detected again, replace ECM. If 1st trip DTC P1065 is not detected, test is complete.