DTC Confirmation Test
WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If target idle speed is not 625-725 RPM (A/T) or 575-675 RPM (M/T), perform idle air volume learning before proceeding. See PROGRAMMING
.
NOTE:
Before proceeding, ensure battery voltage is more than 11 volts at idle and ambient temperature is more than 14°F (-10°C).
- Open hood. Start engine and warm to normal operating temperature. Turn ignition off and wait at least 10 seconds. Turn ignition on. Select DATA MONITOR mode with CONSULT-II.
- Start engine let it idle for at least one minute. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.