LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0500: Vehicle Speed Sensor >> DTC Confirmation Test (Using CONSULT-II)

DTC Confirmation Test (Using CONSULT-II)

WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine. Read VHCL SPEED SE in DATA MONITOR mode with CONSULT-II. VHCL SPEED SE should be able to exceed 6 MPH when drive wheels are rotating at 6 MPH or more. If operation is as specified, go to next step. If operation is not as specified, go to DIAGNOSTIC PROCEDURE  .
  2. Select DATA MONITOR mode with CONSULT-II. Warm engine to normal operating temperature. Maintain the following conditions for at least 10 consecutive seconds:
    • ENG SPEED: more then 1800 RPM.
    • COOLAN TEMP/S: more than 158°F (70°C).
    • B/FUEL SCHDL: 5.5-14.0 msec (A/T) or 6.0-14.0 msec (M/T).
    • PW/ST SIGNAL: OFF.
  3. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals