LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0133: Ho2S1 Circuit Slow Response - Bank 1 Or DTC P0153: Ho2S1 Circuit Slow Response - Bank 2 >> DTC Confirmation Test (Using Generic Scan Tool)

DTC Confirmation Test (Using Generic Scan Tool)

WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use the following test to check overall function of HO2S1 circuit. During this test, 1st trip DTC may not be confirmed.
CAUTION: DO NOT use ECM ground terminals when measuring voltage.
  1. Start engine and warm to normal operating temperature. Measure voltage between ground and ECM terminal No. 91 (bank 1) or No. 92 (bank 2) by backprobing. See Figure and Figure .
  2. While observing voltmeter, increase engine speed to 2000 RPM. Voltage should cycle from less than .3 volt to more than .6 volt and back more than 5 times within 10 seconds. If voltage is not as specified, go to DIAGNOSTIC PROCEDURE  . If voltage is as specified, system is okay at this time.
scientia non olet · About LEMON Manuals