Diagnostic Procedure
WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect IAT sensor harness connector. See Figure . Measure resistance between IAT sensor terminals No. 3 and 5 (component side). See Figure . Resistance should be within acceptable range shown in illustration. See Figure . If resistance is as specified, go to next step. If resistance is not as specified, replace IAT sensor.
- No problem is indicated at this time. Problem may be intermittent. See INTERMITTENTS in TROUBLE SHOOTING - NO CODES article.