LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Engine Controls - Basic Diagnostic Procedures - 4 CYL & V6) >> Ignition Checks >> DISTRIBUTORLESS Ignition System >> Ignition Coil Power Source & Ground

Ignition Coil Power Source & Ground

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Nissan Xterra, 2002 Nissan Sentra, 2002 Nissan Quest, 2002 Nissan Pathfinder, and 2002 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect 3-pin ignition coil harness connector. Turn ignition on. Measure voltage between ground and terminal No. 3 (Red wire on I35, Maxima, Pathfinder and QX4, Green/White wire on Sentra) at ignition coil harness connector.
  2. If voltage is present, go to next step. If voltage is not present, check continuity of entire circuit between battery and ignition coil, including fusible link and ignition switch. See WIRING DIAGRAMS article.
  3. Turn ignition off. Check continuity between ground and ignition coil connector terminal No. 2 (Black wire). If continuity is not present, repair ground circuit between ignition coil connector and ground. Repeat test for remaining coils.
scientia non olet · About LEMON Manuals