Removal and Installation for High-pressure Pipe: Installation
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Replace the O-ring of the high-pressure pipe with a new one, then apply compressor oil to it when installing it.
- When charging refrigerant, check for leaks.
- High pressure pipe (evaporator side) mounting bolt
- Tightening torque : 2.9 - 5.9 N.m (0.29 - 0.60 kg-m, 26 - 52 in lb)
- Bolt mounting the high-pressure pipe (condenser side)
- Tightening torque : 7.8 - 19.6 N.m (0.8 - 1.9 kg-m, 69 - 173 in-lb)
- High pressure pipe (evaporator side) mounting bolt