Removal & Installation (4WD Models)

WARNING: This page is about a different car, the 2004 Nissan Pathfinder and 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Support transmission and transfer case. Remove crossmember.
Lower transmission and transfer case as much as possible.
Remove bolt and revolution sensor. See Fig 1 .

Fig 1: Locating Revolution Sensors
Courtesy of NISSAN MOTOR CO., U.S.A.
To install, reverse removal procedure. Install NEW "O" ring on revolution sensor. Tighten bolts to specification. See TORQUE SPECIFICATIONS