Removal & Inspection

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Figure and Figure while performing the following procedure.

Raise and support vehicle. Remove wheel. Set a jack under the rear lower link to relieve the coil spring tension, then remove the shock absorber lower end bolt.
Lower jack supporting the rear lower link.
Remove the shock absorber upper end nuts using power tool.
Inspect shock absorber. Check shock absorber for deformation, cracks or damage, and replace if necessary. Check piston rod for damage, uneven wear or distortion, and replace if necessary. Check welded and sealed areas for oil leakage, and replace if necessary. Check seal of mount seal bracket. If any crack, deformation or deterioration is found, replace the mount seal bracket as assembly.