LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 289 (Rear Suspension) >> Removal & Installation >> Rear Suspension Member >> Removal

Rear Suspension Member: Removal

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Figure while performing the following procedure.
  1. Raise and support vehicle. Remove wheel. Disconnect parking brake cable at front end. Remove brake caliper assemblies and rotors. Disconnect ABS sensor.
    NOTE: Leave brake line connected to brake caliper. Be careful not to depress brake pedal, or piston will pop out. Do not pull or twist brake hose.
  2. Remove center exhaust tube and muffler.
  3. Remove upper end nuts of shock absorber.
  4. Remove suspension member mounting nuts. Then draw out rear axle and rear suspension assembly.
  5. Remove fixing bolts and nuts of member stay, then remove member stay from vehicle and suspension member.
scientia non olet · About LEMON Manuals