Transverse Link & Ball Joint: Installation
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Position transverse link and ball joint assembly. Install pivot bolt or nut. Ensure proper position of compression rod clamp and install. DO NOT tighten transverse link nuts and bolts to specification at this time. Perform final tightening with vehicle on ground.
- To complete installation, reverse removal procedure. Place vehicle on ground. Bounce vehicle up and down several times. Tighten transverse link nuts and bolts to specification. See TORQUE SPECIFICATIONS . Check wheel alignment. See WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES in ADJUSTMENTS & INSPECTION.