Transverse Link & Ball Joint: Removal
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Remove wheel. Remove hub and knuckle assembly. See HUB & KNUCKLE ASSEMBLY .
- Remove the mounting nuts, washer and bushing from the lower side of the stabilizer connecting rod.
- Loosen the transverse link mounting bolts a little. Remove mounting bolts from the compression rod bracket.
- Remove the mounting bolts and nuts from the transverse link, then remove it from the suspension member.