Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC WITH TCM
Refer to "DTC INSPECTION PRIORITY CHART ".

OK or NG

OK: GO TO 2.

NG: Repair or replace.
CHECK STARTING SYSTEM
Turn ignition switch OFF, then turn it to START.

Does starter motor operate?

Yes or No

Yes: GO TO 3.

No: Refer to "SYSTEM DIAGRAM ".
CHECK PNP INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT-II
1. Disconnect ECM harness connector.
2. Check harness continuity between ECM terminal 102 and combination meter terminal 7.
  Refer to WIRING DIAGRAM .
  
  Continuity should exist .
3. Also check harness for short to ground and short to power.
OK or NG

OK: GO TO 5.

NG: GO TO 4.
DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E152, M31
- Harness for open or short between ECM and combination meter
Repair open circuit or short to ground or short to power in harness or connectors.
CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".

OK or NG

OK: GO TO 6.

NG: Repair or replace.
REPLACE COMBINATION METER
Refer to "REMOVAL AND INSTALLATION ".

INSPECTION END