LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2412 (Engine Control System - DTCS U0101 To P0183 (VQ40DE)) >> DTC P0138, P0158: Ho2S2 >> DTC Confirmation Procedure >> Procedure For Malfunction B

Procedure For Malfunction B

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

With CONSULT

TESTING CONDITION: 

For better results, perform DTC WORK SUPPORT at a temperature of 0 to 30 °C (32 to 86 °F)  .

  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
  2. Start engine and warm it up to the normal operating temperature.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Turn ignition switch ON.
  5. Turn ignition switch OFF and wait at least 10 seconds.
  6. Start engine and keep the engine speed between 3, 500 and 4, 000 RPM for at least 1 minute under no load.
  7. Let engine idle for 1 minute.
  8. Make sure that "COOLAN TEMP/S" indicates more than 70°C (158°F).

    If not, warm up engine and go to next step when "COOLAN TEMP/S" indication reaches 70°C (158°F).

  9. Open engine hood.
  10. Select "HO2S2 (B1) P1146" (for DTC P138) or "HO2S2 (B2) P1166" (for DTC P0158) of "HO2S2" in "DTC WORK SUPPORT" mode with CONSULT.
  11. Follow the instruction of CONSULT.
    NOTE: It will take at most 10 minutes until "COMPLETED" is displayed.
  12. Make sure that "OK" is displayed after touching "SELF-DIAG RESULTS".

If "NG" is displayed, refer to "DIAGNOSIS PROCEDURE ".

If "CAN NOT BE DIAGNOSED" is displayed, perform the following.

  1. Turn ignition switch OFF and leave the vehicle in a cool place (soak the vehicle).
  2. Return to step  1.
scientia non olet · About LEMON Manuals