DTC Confirmation Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive at a safe speed.

NOTE:

If DTC P0011 or P0021 is displayed with DTC P0075 or P0081, first perform trouble diagnosis for DTC P0075 or P0081. Refer to P0075, P0081 IVT CONTROL SOLENOID VALVE .

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next step.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is between 10V and 16V at idle .

WITH CONSULT

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
Start engine and warm it up to the normal operating temperature.

Maintain the following conditions for at least 6 consecutive seconds. Hold the accelerator pedal as steady as possible.

ENG SPEED	1, 200 - 2, 000 RPM
COOLAN TEMP/S	More than 60°C (140°F)
B/FUEL SCHDL	More than 3.5 msec
Selector lever	P or N position

Stop vehicle with engine running and let engine idle for 10 seconds.
Check 1st trip DTC.
If the 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
If the 1st trip DTC is not detected, go to next step.

Maintain the following conditions for at least 20 consecutive seconds.

ENG SPEED	1, 700 - 3, 175 RPM (A constant rotation is maintained.)
COOLAN TEMP/S	More than 70°C (158°F)

selector level	1st or 2nd position
Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

Check 1st trip DTC.
If the 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT" above.