LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2406 (Engine Control System - DTCS P0603 To P2A03 (VK56DE)) >> DTC P1140, P1145: IVT Control Position Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next step.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Select "DATA MONITOR" mode with CONSULT.
  4. Maintain the following conditions for at least 10 seconds.
    Engine speed More than idle speed
    Selector lever P or N position
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About LEMON Manuals