LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2391 (Engine Control System - DTCS P1550 To P2A03) >> DTC P1572 ASCD Brake Switch >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine (VDC switch OFF).
  2. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 1: Identifying CONSULT-II Display - DATA MONITOR
    G04900667Courtesy of NISSAN NORTH AMERICA, INC.
  3. Press MAIN switch and make sure that CRUISE indicator lights up.
  4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VEHICLE SPEED CONDITION CHART

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Selector lever Suitable position

    If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If DTC is not detected, go to the following step.

  5. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VEHICLE SPEED CONDITION CHART

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Selector lever Suitable position
    Driving location Depress the brake pedal for more than five seconds so as not to come off from the above-mentioned vehicle speed.
  6. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals