LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2342 (Engine Control System - DTCS P0448 To P0850) >> DTC P0603 ECM Power Supply >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
  2. Start engine and let it idle for 1 second.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Turn ignition switch ON and wait at least 1 second.
  5. Repeat step 2 to 4 for 4 times.
  6. Check 1st trip DTC.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "
scientia non olet · About LEMON Manuals