LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2341 (Engine Control System - DTCS P0137 To P0447) >> DTC P0444, P0445 EVAP Canister Purge Volume Control Solenoid Valve >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm battery voltage is more than 11V at idle  .

WITH CONSULT-III 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Start engine and let it idle for at least 13 seconds.
  4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

WITH GST 

Follow the procedure "WITH CONSULT-III" above.

scientia non olet · About LEMON Manuals