LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2341 (Engine Control System - DTCS P0137 To P0447) >> DTC P0340, P0345 CMP Sensor (Phase) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10.5V with ignition switch ON  .

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ."

    If 1st trip DTC is not detected, go to next step.

  5. Maintaining engine speed at more than 800 rpm for at least 5 seconds.
  6. Check 1st trip DTC.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ."
scientia non olet · About LEMON Manuals