Diagnostic Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
With CONSULT-III
1. Turn ignition switch ON.
2. Select "SELF-DIAG RESULTS" mode with CONSULT-III.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure .
  See "DTC CONFIRMATION PROCEDURE ."
5. Is the DTC U1010 displayed again?
With GST
1. Turn ignition switch ON.
2. Select "Service $04" with GST.
3. Perform DTC Confirmation Procedure .
  See "DTC CONFIRMATION PROCEDURE ."
4. Is the DTC U1010 displayed again?
  Yes or No
  
  OK: GO TO 2.
  
  NO: INSPECTION END
REPLACE ECM
1. Replace ECM.
2. Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Refer to "NVIS (NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS) ."
3. Perform "VIN REGISTRATION ."
4. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ."
5. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ."
6. Perform "IDLE AIR VOLUME LEARNING ."
>> INSPECTION END