LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2281 (Roof) >> Removal And Installation >> Sunroof System >> Adjustment >> Height Difference Adjustment

Height Difference Adjustment

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

If an excessive height difference between glass lid assembly and roof panel is found, adjust in the following manner:

  1. Remove headlining. Refer to "REMOVAL AND INSTALLATION ".
  2. Loosen sunroof unit nuts and sunroof bracket bolts.
  3. Add shims until gap is within specification "A-A" as shown.
    NOTE: Temporarily snug nuts and bolts to prevent movement between each adjustment.
  4. Tilt glass lid assembly up and down several times to check that it moves and seals properly.
  5. Tighten sunroof unit nuts and sunroof bracket bolts.
    NOTE: First tighten left front then right rear sunroof unit nuts to prevent uneven torque while tightening remaining sunroof bracket bolts.
  6. Install headlining. Refer to "REMOVAL AND INSTALLATION ".
scientia non olet · About LEMON Manuals