Door Lock System

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before performing the diagnosis in the following table, check "Work flow". Refer to "WORK FLOW ".
If the following symptoms" are detected, check systems shown in the "Diagnosis/service procedure" column in this order.

Symptom	Repair order	Refer to
Key reminder door function does not operate properly.	1. Door switch check	DOOR SWITCH
	2. Key switch (Insert) check	KEY SWITCH (BCM INPUT)
	3. Replace BCM.	REMOVAL AND INSTALLATION
Power door lock does not operate with door lock and unlock switch on main power window and door lock/unlock switch or power window and door lock/unlock switch RH.	1. Door lock/unlock switch check (driver side)	DOOR LOCK AND UNLOCK SWITCH
	2. Door lock/unlock switch check (passenger side)	DOOR LOCK AND UNLOCK SWITCH
Specific door lock actuator does not operate.	1. Door lock actuator check (Front LH)	DOOR LOCK ACTUATOR
	2. Door lock actuator check (Front RH)	DOOR LOCK ACTUATOR
	3. Door lock actuator check (Rear LH)	DOOR LOCK ACTUATOR
	4. Door lock actuator check (Rear RH)	DOOR LOCK ACTUATOR
	5. Back door lock actuator check	DOOR LOCK ACTUATOR
	6. Glass hatch lock actuator check	GLASS HATCH LOCK ACTUATOR
Back door does not operate using back door opener switch (door locks are open).	1. Check back door opener switch	BACK DOOR OPENER SWITCH
	2. Check back door lock actuator.	DOOR LOCK ACTUATOR
Glass hatch does not open using glass hatch ajar switch (door locks are open).	1. Check glass hatch ajar switch	GLASS HATCH AJAR SWITCH
	2. Check glass hatch lock actuator.	GLASS HATCH LOCK ACTUATOR
Power door lock does not operate with front door key cylinder LH operation.	1. Front door lock assembly LH (key cylinder switch) check	KEY CYLINDER SWITCH
	2. Replace BCM.	REMOVAL AND INSTALLATION
Power door lock does not operate.	1. BCM power supply and ground circuit check	POWER SUPPLY AND GROUND CIRCUIT
	2. Door lock/unlock switch check (driver)	DOOR LOCK AND UNLOCK SWITCH
	3. Door lock/unlock switch check (passenger)	DOOR LOCK AND UNLOCK SWITCH
Vehicle speed sensing auto LOCK operation does not operate.	1. Ensure automatic door lock/unlock function (lock operation) is enabled.	DIAGNOSIS SYSTEM (BCM)
	2. Check combination meter vehicle speed signal.	DTC B2205 VEHICLE SPEED CIRCUIT
	3. Check intermittent incident.	INTERMITTENT INCIDENT
Ignition OFF interlock door UNLOCK function does not operate.	1. Ensure automatic door lock/unlock function (unlock operation) is enabled.	DIAGNOSIS SYSTEM (BCM)
	2. Check BCM for DTCs.	FAIL SAFE
	3. Check intermittent incident.	INTERMITTENT INCIDENT